From Sumo
Revision as of 11:31, 11 July 2017 by Namdre (talk | contribs) (bicycle speed distribution)
Jump to navigation Jump to search

Bicycle Simulation

This page describes simulations of bicycles in SUMO. To build an intermodal simulation scenario with bicycles, additional steps have to be take in comparison to a plain vehicular simulation.

The simulation of bicycles is a developing subject and still carries some difficulties. These are discussed below.

Approaches to bicycle modelling

Currently, no exclusive movement model for bicycles is implemented. Existing models need to be re-purposed

Bicycles as slow vehicles

In this case, vehicles are specified as vehicles with the appropriate type:

<vType id="bike" vClass="bicycle"/>
<vehicle type="bike" .../>

Note, that that the guiShape="bicycle" along with sensible default parameters are automatically used when specifying vClass="bicycle". By adapating vType-parameters for acceleration,deceleration,maximumSpeed,etc.. different cyclist types can be modelled.

Problems and workarounds

  • Turning left by crossing twice does not work. Extra edges need to be added to accommodate these trajectories.
  • No bi-directional movements on bicycle lanes
  • No shared space for bicycles and pedestrians
  • No overtaking by vehicles on a single-lane road. This can be fixed by using the Sublane Model.
  • The intersection model has no special adaptations for bicycles. This results in unrealistic (large) safety gaps when bicycles are approaching a large priority intersection from a prioritized road
  • The road speed limit is not meaningful for bicycles. To model a speed distribution for bicycles with a single vehicle type, a speed limit corresponding to the median speed of the bicycles should be set for the cycling lanes.

One way for overcoming most of these problems is to control bicycle movements at intersections with an external control script. This approach is described in Integration of an external bicycle model in SUMO, Heather Twaddle 2016.

Bicyles as fast pedestrians

In this case, persons walking at high speed are used.

Problems and workarounds

  • No support for proper visualization
  • Movement model is not validated

Building a network for bicycle simulation

Automatic import

The import of bicycle lanes from OpenStreetMap is supported since version 0.24.0. To use this, an appropriate typemap must be loaded.

Explicity specification

Bike lanes may be defined explicitly in plain XML input when describing edges (plain.edg.xml). This is done by defining an additional lane which only permits the vClass “bicycle” and setting the appropriate width. In this case it is important to disallow bicycles on all other lanes. Also, any pre-exisiting connection definitions must be modified to account for the new sidewalk lane.

Notes on Right-of-Way rules

When using bicycle lanes in a network, right-turning vehicles must yield for straight-going bicycles. The intersection model supports these right-of-way rules and builds internal junctions where appropriate.

Likewise, left-turning bicycles one a bicycle lane (on the right side of the road) must yield to straight-going vehicles.

The trajectories of left-turning bicycles use a wide curve rather than going straight twice. Currently, this can only be remedied by setting custom shapes for these internal lanes.